Free Programming instructions for 2002, 2003, 2004, 2005, and 2006 Mitsubishi Lancer remote keyless entry fob alarm

How to program your 2002, 2003, 2004, 2005, and 2006 Mitsubishi Lancer remote keyless entry fob alarm by yourself at home without going to the dealer.

IMPORTANT: Before entering programming mode, have in possession all of the transmitters you will be using on the vehicle. Once you program the transmitter, all previous codes will be erased from the memory. The other transmitters will not be functional until you program the transmitters again. You can program up to 4 remotes

1. Switch ignition OFF
2. Access the programming connector DLC (located in drivers side fascia)
(To see a picture of the Data Link Connector, you can click on the link below)
3. Jump programming connector terminals 1 and 4 (or ground)
4. Within 10 seconds press hazard switch 6 times
5. Doors should lock and unlock to confirm programming mode
6 Press and release remote transmitter LOCK button
7 Within 10 seconds press remote transmitter LOCK button twice
8 Doors should lock and unlock to confirm programming
9 If programming additional remotes within 1 minute repeat button procedure ( #6 ) for each additional remotes
10 To exit programming mode remove key from ignition or jump lead

http://blog.carandtruckremotes.com/2012/06/06/what-is-a-data-link-connector-also-called-the-dlc/

2 thoughts on “Free Programming instructions for 2002, 2003, 2004, 2005, and 2006 Mitsubishi Lancer remote keyless entry fob alarm

  1. I tried doing this a couple of times. On the part where You press the hazard button 6 times, nothing happens. The doors don’t lock or unlock. We have two keys for the car and I’ve tried both. No luck. Am I right to say that the keys I have are not master keys?
    Any help will be greatly appreciated.
    Thank you!

    • If you still aren’t having any luck, you can try rebooting the keyless system by doing an electrical reset on the vehicle.
      To do this you would simply disconnect one of the car’s battery cables for about 15-20 minutes, reconnect and then try the programming again.
      Sometimes this will solve any ‘bugs’ that may be keeping the remote from programming.

Leave a Reply

Your email address will not be published. Required fields are marked *

3 × one =