FREE keyless entry remote fob programming instructions for 1997, 1998, 1999, 2000, 2001, 2002, 2003, and 2004 Oldsmobile Silhouette

This is how to program your 1997, 1998, 1999, 2000, 2001, 2002, 2003, and 2004 Oldsmobile Silhouette keyless entry remote yourself at home without going to the dealer…

Have all remotes with you during programming procedure.
1. Remove key from ignition switch
2. Remove the “BCM PRGRM” fuse from the fuse box
3. Close all doors
4. Turn ignition switch to the “ACC” position
5. Within 1 second, turn the ignition switch “OFF” and then back to “ACC”
6. To program the remote proceed as follows:
*Press and hold the Lock and Unlock buttons on the remote simultaneously until a chime sounds,
approximately 14 Seconds.
7. Repeat step 6 for each additional remote transmitter you have.
8. Remove key from ignition switch
9. Refit the “BCM PRGRM” fuse into the fuse box.

2 thoughts on “FREE keyless entry remote fob programming instructions for 1997, 1998, 1999, 2000, 2001, 2002, 2003, and 2004 Oldsmobile Silhouette

  1. My 2002 Oldsmobile Silhouette wont go into the learn mode. NAPA claims it is asking for a security code, typically they don’t require this. The dealer mentioned something a few months ago about the computer wasn’t reading right. any suggestions?

    • If you still aren’t having any luck, you can try rebooting the keyless system by doing an electrical reset on the vehicle.
      To do this you would simply disconnect one of the car’s battery cables for about 15-20 minutes, reconnect and then try the programming again.
      Sometimes this will solve any ‘bugs’ that may be keeping the remote from programming.

Leave a Reply

Your email address will not be published. Required fields are marked *

1 × five =