2004, 2005, and 2006 Toyota Tundra (Factory Installed) free programming instructions for replacement remote keyless entry fob alarm

This is how to program your 2004, 2005, and 2006 Toyota Tundra (Factory Installed) replacement remote keyless entry fob alarm by yourself at home without going to the dealer.
There is also a video below the written instructions that shows how easy this is done.

Driver’s door open, key removed from ignition switch.
Within 5 seconds:
Insert and remove the key from the ignition switch twice.
Within 40 seconds:
Close and open driver’s door twice.
Insert and remove the key from the ignition switch.
Within 40 seconds:
Close and open driver’s door twice.
Insert the key into the ignition switch and close the driver’s door.
Switch ignition ON and OFF once to program a remote transmitter code whilst retaining the original codes or twice to program a remote transmitter code whilst erasing the original codes.
Remove key from ignition switch:
System should now lock and unlock vehicle once, twice or five times depending which mode has been selected. One to four times, slowly, to indicate number of remote transmitters registered.
Within 40 seconds:
Press and hold LOCK and UNLOCK remote buttons simultaneously for 1.5 seconds
Within 3 seconds:
Press LOCK button.
System should now lock and unlock vehicle once to confirm registration, twice to indicate registration has failed.
Within 40 seconds:
Repeat button procedure to program remaining remote transmitters.
NOTE: To exit programming mode: Open driver’s door. NOTE: A maximum of 4 remote transmitters can be programmed.

For more information about these remotes, or to place an order, please click on the link below:
http://www.carandtruckremotes.com/toyota-remotes-tundra-remotes.html

Leave a Reply

Your email address will not be published. Required fields are marked *

three × 5 =

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>