How to program Buick Enclave keyless remote for 2008, 2009, 2010 models

Buick Enclave keyless remote programming 2008, 2009, 2010

Note. 2011 to 2014 remotes must be programmed by a dealer or car locksmith

 

Switch ignition ON.

Repeatedly press vehicle information button (it is usually located on the right or left from the steering column depending on year make and model) Fig. 2 [A] until PRESS TO RELEARN REMOTE KEY is displayed.

Press set/reset button Fig. 2 [B] until REMOTE KEY LEARNING ACTIVE is displayed.

Programming mode activated, proceed as follows:

Press and hold LOCK and UNLOCK remote buttons on first remote transmitter simultaneously for 15 seconds.

Wait for acoustic signal (indicates correct programming).

Repeat above procedure to program remaining remote transmitters.

Switch ignition OFF to exit programming mode.

Remote transmitters can also be programmed using diagnostic equipment.

NOTE: A maximum of 8 remote transmitters can be programmed.

 

To order a remote or for more information, click on the link below:

http://www.carandtruckremotes.com/buick-remotes-enclave-remotes.html

2 thoughts on “How to program Buick Enclave keyless remote for 2008, 2009, 2010 models

Leave a Reply

Your email address will not be published. Required fields are marked *

1 × 3 =