How to program Buick Regal keyless entry remote 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004 and 2005

Free remote programming instructions for 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004 and 2005 Buick Regal Entry keyless entry remotes.
1997 to 2000 remote on the left and 2001 and up on the right.

014aztek

1) Sit in the driver’s seat
2) Remove the ignition key from the ignition lock cylinder
3) Close all the doors
4) Press and hold unlock on the door lock switch (on the door)
5) While holding the door lock switch in the unlock postition, insert and remove the ignition key twice.
DO NOT ROTATE THE KEY, JUST SLIDE IT IN AND BACK OUT.
6) Insert the ignition key the third time, leaving the key in in the ignition cylinder.
DO NOT TURN KEY
7) Release the door lock switch. You will hear 3 chimes indicating the transmitter programming is active.
8) Press and hold the lock and unlock buttons on the keyless entry remote at the same time (one remote) for 12
seconds. You will hear two chimes. This indicates the transmitter has been programmed.
9) Repeat step (8) for all additional transmitters (all existing remotes) to be programmed
10) Exit programming by removing the key from the ignition cylinder.

To order a remote or to learn more about this product, please click on the link below:

http://www.carandtruckremotes.com/buick-remotes-regal-remotes.html

2 thoughts on “How to program Buick Regal keyless entry remote 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004 and 2005

  1. Well, another way that doesn't work. What else should I try? I've tried the 1 & 4 old, the holding door unlock and ignition on & off and now the one you suggest with no succes. on said:

    Well, another way that doesn’t work. What else should I try? I’ve tried the 1 & 4 old, the holding door unlock and ignition on & off and now the one you suggest with no succes.

    • If you still aren’t having any luck, you can try rebooting the keyless system by doing an electrical reset on the vehicle.
      To do this you would simply disconnect one of the car’s battery cables for about 15-20 minutes, reconnect and then try the programming again.
      Sometimes this will solve any ‘bugs’ that may be keeping the remote from programming.

Leave a Reply

Your email address will not be published. Required fields are marked *

5 − two =