How to program your 1993, 1994, 1995, 1996 and 1997 Ford Thunderbird remote keyless entry fob alarm by yourself at home without going to the dealer.
Obtain all remote transmitters
Access program connector taped to the wiring harness located in trunk (LH)
Switch ignition ON
Momentarily jump program connector terminals
Door should lock then unlock
Remove jump wire program connector
Press any button on the first remote transmitter
Doors should lock then unlock
Press any button on the second remote transmitter
Doors should lock then unlock
Press any button on the third remote transmitter
Doors should lock then unlock
Press any button on the fourth remote transmitter
Doors should lock then unlock
Note: if door locks do not operate: press button again up to a maximum of 3 times
Switch ignition OFF:
Doors should lock then unlock
Note: a maximum of 4 remote transmitters can be programmed
3 thoughts on “Free Programming instructions for 1993, 1994, 1995, 1996 and 1997 Ford Thunderbird remote keyless entry fob alarm”
You must log in to post a comment.
Worked perfectly on a 1997 Ford Thunderbird LX.
For those who don’t know, this connector is in the trunk, on the left (driver’s) side. Pull down the stiff fabric cover right by the trunk hinge. The connector is mounted on the side of the cover for the electronics. No need to remove the cover itself. And I just used the key itself to jumper across the 2 pins.
THANK YOU FOR THIS INFO ! ! !
and worked fantastic on 94 t-bird , The connector is so in the open I looked all over and finally thought …. can this really be it ????… wow 30 seconds or less it was done
thanx
Great!