1991, 1992, 1993, 1994, and 1995 Toyota MR2 free programming instructions for replacement remote keyless entry fob alarm

This is how to program your 1991, 1992, 1993, 1994, and 1995 Toyota MR2 replacement remote keyless entry fob alarm by yourself at home without going to the dealer.

I. To program (add) a REMOTE CONTROL to the system:
1. Insert the key into ignition switch,
and turn it to “ON”.
2. Press and hold the ECU’s
PROGRAMMING SWITCH for 3
seconds.
The STATUS MONITOR LED
turns on for 5 seconds.
NOTE:
YOU MUST PERFORM THE NEXT
STEP WITHIN 5 SECONDS.
3. Press and release a REMOTE
CONTROL’s top or bottom
button.*
The STATUS MONITOR LED
turns off.
The Piezo “chirper” chirps once.
The exterior lights flash once.
4. Turn off the ignition. The ECU will
now operate with the REMOTE
CONTROL just programmed.
* Either button on your REMOTE CONTROL can be programmed to operate the system. The bottom
button can be programmed to operate a second vehicle with the Toyota VIP.
Programming
Procedure
Press and Hold
for 3 Seconds
Lights Up
Press Once

II. To erase all REMOTE CONTROL codes from the system:
1. Insert key into the ignition switch,
and turn it to “ON”.
2. Press and hold the ECU’s
PROGRAMMING SWITCH for 3
seconds.
The STATUS MONITOR LED
turns on for 5 seconds.
NOTE:
YOU MUST PERFORM THE NEXT
STEP WITHIN 5 SECONDS.
3. Press and hold the ECU’s
PROGRAMMING SWITCH for
over 2 seconds again.
The STATUS MONITOR LED
turns off, then flashes 3 times.
The Piezo “chirper” chirps three
times and the exterior lights flash
3 times.
4. Turn off the ignition. The ECU has cleared all REMOTE CONTROL codes; until
another REMOTE CONTROL is programmed, the system will not work with any
REMOTE CONTROL.